|
|
|
 ELECTRIC INJECTION MOLDING COURSE
Electric molding machines now account for over
50% of new machine sales. There are several reasons for their popularity; more precise control, lower electricity consumption and potentially faster cycles are among the reasons. But along with these and other advantages are potential problems. These machines require an understanding of this new technology by the operating personnel to gain the benefits and avoid very expensive mistakes. In short, they require more knowledgeable personnel at all levels.
Now available, Paulson offers a new three-lesson Electric Injection Molding Machine course. This new course integrates into the Paulson 15 lesson Practical Injection Molding training course. Molders who already have the 15 lesson course and are interested in Electric molding machines will want to integrate this new course into their training program. Others may just want to start out with just the All-Electric course.
|
| The All-Electric Molding Machine Course |
| Lesson 1 :: |
Electric Machine Design, Cycle & Parts
• The parts of the Electric molding machine
• How Electric molding machines work
• Comparing the operation of the Electric and the Hydraulic
molding machine
• Operation of the ball screw drive
• The molding cycle
• Instruments and controls used on these machines
• Typical operating conditions |
| Lesson 2 :: |
The Effects of Each Control
• Safety around these machines
• Machine modes of operation: manual, semi-automatic and automatic
• Explanation and effects of the injection controls: injection rates and
pressures, vpt settings, back pressure, shot size, cushion, control
change ramps, decompression and others. |
| Lesson 3 :: |
Optimizing Electric Machine Settings
• Clamp settings: control of clamp distance and speed, clamp force,
safety concerns.
• Ejector control
• Optimizing the machine control settings
• Process recordings
• Procedures for utilizing the advantages of the Electric machine. |
| |
As always, every Paulson course includes student workbooks so that the student has a permanent record of what has been learned and to add or make notes as he or she is taking the course.
Course Pricing:
Electric Injection Molding Course with Practical Injection Molding - $5,500
Electric Injection Molding Course only - $3,500
Special Offers:
• Pre-purchase now until July 15th and receive 15% off our new
Electric course.
• For a limited time only, customers purchasing Paulson’s Practical
Injection Molding course receive the New Electric Injection Molding
Course at no extra cost. |
 Click here to view a sample of this course.
|
|
